RawlplugRawlplug

High strength and versatile application in cracked and non-cracked concrete with internally threaded sockets (ITS)

Approved for use in cracked and non-cracked concrete (EAD 330499-01-0601), working life up to 100 years
Allows removal of bolt to leave a re-usable socket in place
Winter version can be used in warmer temperatures for faster curing
Suitable for use in dry and wet substrates as well as holes and substrates covered with water
Rapid bonding time enables quick execution of works
Very high load capacity
Anchor does not generate tensions in the substrate which enables R-KER to be specified where closer edge and spacing distances are required
Suitable for multiple use. Partly used product can be reused after fitting new nozzle
Tests in fire conditions confirm the fire resistance up to R120

Product Code	Resin	Description / Resin Type	Volume
Product Code	Resin	Description / Resin Type	[ml]
R-KER-II-300	R-KER-II	R-KER II Hybrid Resin	300
R-KER-II-345	R-KER-II	R-KER II Hybrid Resin	345
R-KER-II-400	R-KER-II	R-KER II Hybrid Resin	400
R-KER-II-300-S	R-KER-II-S	R-KER II Hybrid Resin for High Temperature (Summer) / Slow Cure Styrene Free Hybrid Resin	300
R-KER-II-400-S	R-KER-II-S	R-KER II Hybrid Resin for High Temperature (Summer) / Slow Cure Styrene Free Hybrid Resin	400
R-KER-II-300-W	R-KER-II-W	R-KER II Hybrid Resin for Low Temperature (Winter) / Rapid Cure Styrene Free Hybrid Resin	300
R-KER-II-400-W	R-KER-II-W	R-KER II Hybrid Resin for Low Temperature (Winter) / Rapid Cure Styrene Free Hybrid Resin	400
R-KER-II-300-SV	R-KER-II	R-KER II Hybrid Resin	300

SOCKETS

Drill hole to the required diameter and depth for socket size being used.
Clean the drill hole thoroughly with brush and hand pump at least four times before installation
Insert cartridge into gun and attach nozzle.
Dispense to waste until even colour is obtained (min. 10 cm)
Insert the mixer nozzle to the bottom of the drill hole and inject resin, slowly withdrawing the nozzle as the hole is filled to 70% of its depth.
Immediately insert the socket, slowly and with slight twisting motion. Remove any excess resin around the hole before it sets and leave it undisturbed until the curing time elapses.
Attach fixture and tighten the bolt to the required torque.

SOCKETS

Minimum working and curing time

R-KER-II

*For wet concrete the curing time must be doubled

R-KER-II S

*For wet concrete the curing time must be doubled

R-KER-II W